The stand could be removed and the siren could be mounted differently.įederal Signal 3T22 Sandy Oregon's 3T22 that has been damaged. The siren had a small stand with three legs so it could be mounted on a pole or roof. It proved to be one of the most popular of Federal Signal's omnidirectional sirens and gained a reputation as a reliable multipurpose siren. There were also two air intake spots: also one on the top and bottom. The Federal Signal STH-10 was a single-tone 10-horsepower omnidirectional siren produced by Federal Signal over a span of 50 years. It had two solenoid boxes, one on top, and one on the bottom. It also had a smaller cone on top to reduce rain and other water-related substances such as snow from getting inside. It had ten ports and cones on the bottom and twelve ports and cones on the top. The 3T22 came in only one port ratio: 10/12. Like many other older siren models, these sirens are becoming more uncommon due to their age and because of newer technology. In the early 1990s, the siren's production was stopped when it was replaced with the newer 2001-SRN, which could reach 126db (also measured 100 feet away), hence the name. The siren was mainly used for air raid warnings during the Cold War era and weather warnings after the war. A 3T22A would be three phase, while a 3T22B would be single phase. The A or B determined whether the motor was three phase or single phase. In the name 3T22, the 3 stands for its three main signals: attack (wail), alert (steady), and hi-lo, and the 22 again stands for the twenty-two cones. There are four models of this type of siren. The 2T22 and 3T22 could produce 113db (measured 100 feet away from the siren). The 3T22 was superior in design because it could perform the "hi-lo" signal, which is mainly used for fire calls. In 1955, Federal designed the 3T22, which was similar, except for its name and that it had solenoids. The siren had no solenoids, so it could not perform a "hi-lo" signal. It could produce two main signals (it could produce more but the other signals were rarely used), hence the name "2T22" (the 2 at front representing the 2 choppers, and the 22 representing the amount of horns). The 2T22 had the same number of ports and cones. Known for producing famous sirens such as the Thunderbolt and the 2001 series, they are one of the biggest siren companies around today. The Federal Signal 3T22 was originally designed as the 2T22 in 1952 or 1954. The Federal Signal Corporation is a company that has been producing sirens since 1907, originally beginning as Federal Electric, and later becoming Federal Enterprises and Federal Sign & Signal. It has a very recognizable design, having a ten-port rotor (chopper) on the bottom with ten cones (horns) and a 12-port one on top with twelve cones. The Federal Signal 3T22 / 2T22 was an outdoor warning siren made by Federal Signal Corporation (formerly Federal Sign and Signal Corporation) from 1952 through the early 1990s. Note it has 7 horns on the top, and 12 horns on the bottom, which was an error made by whoever made the advertisements. (Loose cones)įederal Sign & Signal advertising the 2T22.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |